Home >> Material Handling >> Dust Filter Shaker Type

Metal Detectable Products

Engineering Toolbox

Dust Filter - Shaker Type.

 

The SHAPE SH range of 'shaker' type dust filters are a well proven system for the control of dust created during powder handling and processing operations.

 

The units can either be fitted directly into the process to control specific points where high dust loads are created (i.e. Rip & Tip Stations) or as a central dust collection system to multiple points via a ductwork system.

 

The units are fitted with multiple compartment filter bags which will catch the dust during the process operation. The filters are then automatically shaken on a timed basis to clean the filter allowing the captured dust to either be dropped back into the process or collected in a waste collection bin. Depending upon the application the units can either be forced (i.e. fitted with a fan) or natural draught (i.e. silo vent) type.

 

The system is designed to be easy to clean and maintain. A 'quick release'design on the body allows removal of the filters in just a few minutes. The filter cartridges are available in a wide range of materials including polyester, paper and US FDA approved materials.

 

SHAPE can also provide quick release / easy clean ductwork systems utilising specially designed fittings and damper valves to allow a simple dust control system to be installed from a central point.

 

Dust explosion prevention or protection may be required on systems handling dry powder or granular materials. To operate without proper explosion venting may result in fire or explosion. check local industrial codes and policies or consult SHAPE.

 

 
Copyright © 2019 shape.cc. All Rights Reserved.
Joomla! is Free Software released under the GNU/GPL License.